Seat occupancy mat tester emulator kit for BMW 3 Series E36.
Compatible with: BMW 3 Series E36 (1990–2000)
Plug & Play testing solution for faulty seat occupancy sensors and sport seat installations. No coding required.
Simple installation.
- Locate the seat mat connector under the passenger seat
- Unplug the OEM connector
- Plug in the AirbagDoc emulator
- ✔ Plug & Play — no coding required
- ✔ Same or next business day shipping
- ✔ Free worldwide shipping on orders over $40
- ✔ Works with aftermarket & sport seat installations
- ✔ 30-day money-back guarantee
In rare cases, a diagnostic reset may be required to clear stored fault codes.
⚠ Important Notice- This module sets seat occupancy status to permanently occupied
- Do not use when a child seat is fitted to the front passenger seat
- Intended for diagnostic testing, sport applications, and aftermarket seat installations
- AirbagDoc is not responsible for improper use or installation
It plugs into your car's passenger seat wiring in place of the OEM occupancy sensor mat and signals the airbag control module that the seat is permanently occupied. The airbag warning light, caused by bucket seats or a failed OEM mat, goes out.
Sometimes. If the warning light was already on before install, the stored code (93C1 / 93C2 / 93C3 on BMW E-chassis, 930A1A / 930A1B / 930A1C on F-chassis) may need to be cleared with an OBD2 diagnostic tool. Once cleared, it should not return.
Yes. The emulator uses the correct OEM connector for your chassis. No cutting, splicing, or coding required.
OEM seats have a pressure-sensitive occupancy mat inside the cushion. Aftermarket bucket and sports seats don't. Without the expected signal from that mat, the airbag control module logs a fault and lights the warning. The emulator supplies a valid "seat occupied" signal so the module is satisfied.
Yes — covers all E36 variants (sedan, coupé, touring, convertible, compact, M3) produced 1990–2000.
Reviews
There are no reviews yet.